If bare reamer is in stock, drive rods can usually be added within a weeks time.
7 Item Items
Limited quantity only while supplies last
Caution: The reamer pilot is drilled and tapped for the drive rod so be careful not to apply excessive torque. Some barrels may have small bores and it may be necessary to grind pilots down. The standard thrust bushing thickness is .250". NOTE: Drive rods may exhibit slight surface rust. This in no way affects the performance of the reamer itself. It is recommended that drive rods be wiped down with a light oil prior to use. If bare reamer is in stock, drive rods can usually be added within a weeks time.
NOTE: All PTG Reamers and Cutting Tools are designed to work with petroleum-based lubricant. Water-based lubricant can give acceptable results, however the life of the tool will be reduced. For best results use petroleum-based lubricant.